Overview :
● This project demonstrates a simple method to initialize the ESP32-CAM, capture a single image, and save it locally using a Python script.
● It is ideal for basic camera tests, capturing snapshots, and storing images without any additional features or interface.
Features :
● Camera initialization and deinitialization.
● Single image capture.
● Saves captured image as a .jpg file.
● Minimal delay to allow camera stabilization.
Requirement :
Hardware :
● ESP32-CAM module
● UART connector (for flashing and serial communication)
Dependencies :
Make sure you have the following module or support:
● camera module (MicroPython or compatible firmware)
● time module (standard)
Installation & Setup :
● 1. Flash the ESP32-CAM with MicroPython firmware.
● Upload the Python script to the board using tools like ampy or Thonny.
● Save the Code in esp32cam_capture.py
Code for Ultrasonic Sensor and Micro- Servo Motor :
import camera
import time
try:
if camera.init():
print(" Camera initialized successfully!")
time.sleep(2) # wait for camera to stabilize
img = camera.capture()
if img:
print("Image captured successfully!")
print("Image size (bytes):", len(img))
# Save the image to a file
with open("captured_image.jpg", "wb") as f:
f.write(img)
print("Image saved as 'captured_image.jpg'.")
else:
print("❌ Failed to capture image.")
camera.deinit()
else:
print("❌ Camera initialization failed.")
except Exception as e:
print("Error:", e)
How It Works :
● Initializes the ESP32-CAM module.
● Waits 2 seconds to allow the camera sensor to stabilize.
● Captures a single image using camera.capture().
● If successful, the image is saved as captured_image.jpg.
● Deinitializes the camera after use.
Output :
● Image file: captured_image.jpg
● Console logs: camera status and image size.
Running the Capture Script :
● To execute the image capture: python esp32cam_capture.py
● This will initialize the camera, capture a photo, and save it locally. Make sure to run this on the ESP32-CAM with the required environment.